Rear End Components

1" Wide Clamp Fits 3" OD Tube

3" 2 Piece Clamp 1/4 Thick 1.75" Wide

9in Gear Full Spool, New Center Section

Fully assembled 9" Ford center sections are ready to install, complete with PEM nodular iron case, pinion support, premium bearings, 1310 pinion yoke, solid pinion spacer, lightweight steel spool, and competition ring and pinion gears for 31-spline axles.

Axle Shaft, 31 Spline Carrier, 24 Spline Drive Flange, Steel, Natural

Bolt Flat Head Cap Screw Drive Flange 5/16 diameter

Bolt Flat Head Cap Screw Drive Flange5/16 diameter 18 tpi 1/2 long Grade 8 steel UnderCut for use with PEM Drive flanges2 piece Kit

Bolt, 3/8-24 in Thread, 1.00 in Long, Hex Head, Steel, Cadmium, Winters Quick Change

Bolt, 3/8-24 in Thread, 1.00 in Long, Hex Head, Steel, Cadmium, Winters Quick Change

Complete Bearing and Installation Kit for 9” Ford with Carrier Bearings,

3.06" Case with Stock Pinion SupportComplete Bearing and Installation Kit for 9” Ford with Carrier Bearings,Pinion Bearings, pilot bearing, crush sleeve, nuts, pinion seal, Ring gear boltsand gasket. 1.781 ID, 3.06” OD

Differential Lock-Up Plug, 1-3/8 in Long, 31 Spline, Hardware Included, Steel, Natural, Kit

Differential Lock-Up Plug, 1-3/8 in Long, 31 Spline, Hardware Included, Steel, Natural, Kit

Drive Flange Dust Cover, 3-Bolt, O-Ring, 5/16-18 x 5/8 in Long Bolts, Aluminum, Black Anodized, 5 On 5 Hubs, Kit

Drive Flange Dust Cover, 3-Bolt, O-Ring, 5/16-18 x 5/8 in Long Bolts, Aluminum, Black Anodized, 5 On 5 Hubs, Kit

Drive Flange, 5 x 5 in Wheel Bolt Pattern, 24 Spline, 3/4 in Bolt-On Cap / Hardware / O-Ring, 2-1/2 in Grand National Hubs, Kit

PEM Grand National Drive Flange Kit for 5x5" Bolt Pattern

Ford 9 inch Cast Stock Support

Ford 9 inch Crush Sleeve

Ford 9 inch Crush Sleeve