Rear Suspension

1.75" TUBE PULL BAR TAB (PIERCE STYLE)

3 Hole Trailing Arm Mount w/ Double Shock Mount

3/4-16 Steel Jam Nut

Adj Pull Bar Bracket Long Frame Mount

ALUMINUM DOUBLE SIDE QC PINION MOUNT

Same as our WM205, but with an added slot on left side of the pinion to allow a short panhard bar using the same mount. Mount adjusts easily with our climber nut.

ALUMINUM DUAL USAGE PINION MOUNT

Our aluminum dual usage pinion mount is built with 2 identical sides so in the case of an accident you can unbolt the mount, flip it 180 degrees, and you have another good side instead of having to buy 2 mounts to have a spare.

ALUMINUM RIGHT SIDE QC PINION MOUNT

Our aluminum right side quick change pinion mount is a quick adjust climber style for fast adjustments. The slot goes 1-1/2” below pinion center.

Asphalt Top Link Bracket

Axle Housing Retainer Clamp, 2-Piece, Black Anodized, 3 in OD Tube

 Retainer clamp bolts around 3” O.D. axle tubes to keep bird cages, floater brackets and limit chain clamps in position. Two piece design allows clamp to be installed without removing existing brake bracket and hub. 

Birdcage, Center-Pull, 3.000 in ID, Hardware Included, Aluminum, Black Anodized

Birdcage clamps around most 3" O.D. machined axle tubes providing a lower mounting point for a suspension. The two-piece design features a nylon liner allowing clamp to be installed without removing existing brake brackets and hubs. Clamp measures 3-1/4"...

Body Bolt Kit, Frame Mount Bolt, 3/4-16 in Thread, 3.25 in Long, Hex Head, Washer / Spacer / Climber Gear, Steel, Zinc / Black Oxide, Kit

BOLT IN STEEL Q/A LIMITER

Our new Brad Waits designed quick change limit chain adjuster allows you to change your chain length by simply pulling a pin, moving to the next hole and inserting the pin. You can make a chain adjustment in seconds with no tools. This part number is our...