Wehrs Machine and Race Products

Spindle Checker, 1/2-20 in, Steel, Black Zinc

Our Travis Roth inspired spindle checker lets you instantly know after you crash if you need to change your spindle. The spindle checker screws on your 1/2″ fine thread upper ball joint and the...

STEEL Q/A LIMITER FOR 1-1/4″ BAR

Designed by Brad Waits, our steel quick adjust travel limiter allows you to change your chain length by simply pulling a pin, moving to the next hole, and inserting the pin. You can make a chain...

STEEL Q/A LIMITER W/ BELLEVILLE 1-1/2″

Designed by Brad Waits, our steel quick adjust travel limiter allows you to change your chain length by simply pulling a pin, moving to the next hole, and inserting the pin. You can make a chain...

STUD KIT FOR WM301 CARB SPACERS

STUD KIT FOR WM301 CARB SPACERS

Suspension Limiter Chain Clamp, 1-3/4 in OD Tube, Steel, Black Zinc Oxide

This is our clamp ONLY for our travel limiters.

Suspension Limiter Chain Mount

Our adjustable limit chain frame mount is a double adjuster style steel mount with a 3/8″ chain clevis to mount your limit chain to

Suspension Tube, 0.875 in OD, 6 in Long, 5/8-18 in Female Thread, Steel, Black Oxide

Our machined thick wall DOM 5/8″ steel suspension tubes have a 13/16″ hex on each end. These tubes are lasered with length and thread direction for your convenience. Available in 1″...

Swivel Spring Cup Drop Bearing

Our swivel cups will keep your springs happy when traveling by allowing rotation and angular alignment. These cups work with our hollow screw jacks or you can run on a stud on your axle in the rear.

Swivel Spring Short Cup 2 1/2" tall

Swivel-style spring cups are designed to allow rotation and provide angular alignment during spring travel. Available 2-1/2" tall drop bearing version is designed to help car gain side bite.

Swivel Spring Tall Cup 2" Tall

Our swivel cups will keep your springs happy when traveling by allowing rotation and angular alignment. These cups work with our hollow screw jacks or you can run on a stud on your axle in the rear.

T-Bar Adjuster, Bolt-On / Weld-On, 0.75 in Square Bar Mount, 16 Gauge, Aluminum / Chromoly, Black Anodized / Black, Kit

Our rear T-bar adjuster makes it easy to adjust the rear deck to your desired height. The adjuster fits 3/4″ square 16ga wall tube secured with a side bolt or can be welded into the tube...

Tie Rod Stud, 3.000 in Long, Steel, Black Oxide, Bump Steer Kits

The inner tie rod stud is designed to convert your stock inner to a 5/8” heim inner with no drilling. Goes into the stock centerlink or any center link that uses the stock 7 degree taper.